The definitive midi-lathe, Laguna’s REVO 12|16 encapsulates the prestige of Laguna in a small package. Featuring a Pulse Width Modulation system motor to maintain consistent torque at any speed, one step cam-action belt change with magnetic door housing, and a luxury banjo w/45º chamfered edge.
Features
- 1 HP DC Permanent Magnet Motor
- Pulse Width Modulation (PWM) Controller
- Electrical Requirements: 110V-1PH-60Hz
- Recommended Breaker Size: 110V – 15 Amp
- Speed Range High: 650 – 3500 RPM
- Speed Range Mid: 325 – 1750 RPM
- Speed Range Low: 50 – 525 RPM
- Distance Between Centers: 15-½″
- Swing Over Bed: 12-½″
- Swing Over Banjo: 9-½″
- Max Outboard Swing: 16″
- Spindle Bore: ⅜″
- Spindle Thread: 1″ x 8 TPI (Both Ends)
- Front Bearing: 6006LLU
- Rear Bearing: 6005LLU
Additional Details
The 1216 controls the 1hp DC motor using pulse width modulation. A big problem with DC motor control is torque in the low speeds, and you will find many MIDI lathes with the lowest speed of 250RPM and higher because of this. This is because the cost effect controllers introduce resistance into the voltage to limit the power, which reduces the speed but also reduces the torque at the same rate. PWM will deliver full torque across the entire speed range. This allows for tremendous torque in low speeds which is helpful when roughing and precision work. This also allows for outboard turning up to a 16” bowl on a mid-sized lathe.
- Indexing: 24 Positions With Lock
- Accepts Vacuum Chuck: No
- Drive Belt: Poly-V Belt 6 Grooves
- Tailstock Quill: MT #2
- Tail Stock Quill Travel: 2-½″
- Bed Length: 29.4″
- Bed Gap: 1-1/4″
- Tool Rest Length: 6″
- Tool Rest Post Diameter: 1″
- Faceplate Diameter: 3″
- Certification: CSA C/US 256540
- Floor To Bed Height: 6-3/4″ No Pads
- Floor To Spindle Center: 13″ No Pads
- Overall Size (L x W X H): 35.8″ x 14.6″ x 20.5″
- Net Weight: 118 lbs
- Shipping Weight: 125 lbs
- Shipping Dimensions: 37″ x 15″ x 21″
- NEMA Plug: 5-15P
- Cord: 6ft
Sell Sheet
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
