2 3/8in Magnetic bit holder enables use of standard bits with Centrotec Chuck. The Centrotec shank is designed for use with the Festool Centrotec System, as well as with all standard or keyless chucks for no-slip performance. The Centrotec System was designed to provide a seamless transfer of force, eliminating bit slippage or marring of the drill bit. The weight of the drill is reduced by nearly ½ pound, and the length is reduced by nearly 1-1/2†with the Centrotec System. Most importantly, the Centrotec system offers a quicker and more secure means of bit change than any other quick-change chuck system. Thicker and stronger sidewall for longer life and use with impact or standard bits.
- 2 3/8 inches in length provides access to difficult to reach spots
- Adapts all standard bits to the quick change capability of the Centrotec System
- Magnetic insert holds your bits securely in place to prevent loss
- Long, precision milled hex shank eliminates wobble, or run out during use
- Thicker and stronger sidewall for longer life and use with impact or standard bits
- with CENTROTEC interface
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
