Cut Cleanly in Close Quarters with the Xuron 590LP Micro Cutter
- Flush-cuts 20 AWG wire with ultra-quiet 50 PSI air power
- Low-profile head reaches tight spaces other cutters can't access
- Lightweight, ergonomic design prevents hand fatigue
- High-speed cutting boosts productivity and workflow
For electronics techs and manufacturers working in dense, high-focus environments, distraction is disaster. Enter the Xuron 590LP Micro-Pneumatic Cutter. With its slim, relieved head profile, the 590LP slips seamlessly into tight spaces between components to clip wires with virtually no noise or disruption. The ergonomic, feather-light design rests comfortably in your hand for hours of fatigue-free cutting. And at just 50 PSI of air pressure, the 590LP zips through wire-cutting tasks faster than you can say "silence is golden." When your work demands concentration amidst tight spaces, let the 590LP increase your productivity without increasing the noise. For high-density cutting where precision, speed and silence are key, this is your nimble new secret weapon.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
