Monitor and regulate solar input for 12V batteries with the 20 Amp Charge Controller. Designed to integrate seamlessly with Goal Zero solar panels, the charge controller comes with a pre-installed High Power Port and an easy-to-read LED screen. Equipped with an IP65 rating, the charge controller is weather resistant and dustproof, allowing for protection against the elements when powering off-grid adventures or outdoor equipment.
20 AMP CHARGE CONTROLLER
- Designed to monitor and regulate solar input for 12V batteries. For solar charging with 100 watts and below, we recommend the . For solar charging with more than 100 watts, we recommend the 20 Amp Charge Controller.
- Charge Controller comes with an integrated High Power Port for connecting to Goal Zero Boulder 200 solar panels. To connect and charge a 12V battery, you must purchase the and additional cable adaptors. We recommend either the or
- Will not work with Yeti X Power Supply
PORTS
- Input/Output terminal: M5 terminals
- Solar Input Port (High Power Port): 14-23V, up to 20A
- Fuse: 25A replaceable
BATTERY DETAILS
- Charge Controller: PWM
- Rated solar panel amps GZ-10: 20A
- Normal input solar cell array voltage: 15-22V
- Max solar cell array voltage (output has no load): 25V
- Lowest operating voltage at solar or battery side: 8V Minimum
- Charging Characteristics:
- Start Voltage at 25°C: 3-10V
- Charge Voltage at 25°C:
- LTO battery: 14.0V
- Gel battery: 14.1V
- LiFePO4 battery: 14.4V
- Charge Voltage at 25°C: AGM battery-14.4V
- WET battery: 14.7V
- Calcium battery: 14.9V
- Equalizing Voltage at 25°C: WET or Calcium battery-15.5V
- Float Voltage at 25°C:
- Gel, AGM, WET, Calcium batteries-13.6V
- LTO and LiFePO4 batteries-13.4V
- Battery temperature compensation coefficient: -24mV/°C
GENERAL
- Product SKU: 96110
- Weight: 17.6oz (499g)
- Dimensions: 6.10 x 3.90 x 1.02in (15.5 x 9.91 x 2.6cm)
- IP Grade: IP65
- Spade to HPP Cable Length: 3ft
- Operating temperature: -25 to 50°C/ -13 to 122°F
- Warranty: 12 Months
- Certs: IC, FCC, CE-EMC, CE-LVD
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
