Provides constant progressive force to achieve final flexion of the PIP and DIP joints.Turn the positioning nuts on both rods to gain full composite PIP and DIP flexion. The proximal pad slides along the parallel rods, bringing the finger's PIP and DIP joints together. To fit into the splint, at least 90 degrees PIP flexion and 45 degrees DIP passive flexion is needed. The rods can be trimmed using wire cutters. Not intended for thumb use. The proximal and distal pads are covered with soft foam padding for comfort and minimal finger slippage. Not made with natural rubber latex. To size, measure the width at the widest area of the finger.

Quantity: 1

Material: Not made with natural rubber latex

Manufacturer: North Coast Medical

Indications: Provides constant progressive force to achieve final flexion of the PIP and DIP joints.

Options:
Small (NC15678-1)
Medium (NC15678-2)
Large (NC15678-4)
X-Large (NC15678-4)

Sizing Guide:
Width at widest area of finger
Small: 1/2in to 5/8in (1.3 to 1.6cm)
Medium: 5/8in to 3/4in (1.6 to 1.9cm)
Large: 3/4in to 7/8in (1.9 to 2.2cm)
X-Large: 7/8in to 1in (2.2 to 2.5cm)