- Compact metal beveling tool for 45° chamfers and radii of 2 to 3 mm at visible edges
- Surfaces free from oxide and burrs as ideal preparation for the application of powder or paint coatings for maximum protection from corrosion
- One-touch controller: Patented, tool-free setting of the cutting depth in 0.1" steps; stop points for short setting times, and protection against unintentional adjustment of the cutting depth when working
- Slim cutter head with standard carbide indexable inserts and ball-bearing stationary seal ring for working in tubes and in curves
- Guide stop for uniform finish and high surface quality when finishing straight edges
- Bail handle adjusts without tools for secure, even guiding
- Metabo Long-life motor with patented dust protection for long service life
- Vario-Constamatic (VC)-Full wave electronics with thumbwheel for working with materials requiring customized speeds, which remain almost constant under load
- Electronic safety shutdown of the motor for safe working in case the tool stops unexpectedly
- Electronic overload protection, soft start and restart protection
- Slim housing for ideal handling
The machine shown may differ in equipment and technical details depending on the configuration.
Kindly pay attention to delivery scope and product description.
Accessories included only if listed in the delivery scope.
Kindly pay attention to delivery scope and product description.
Accessories included only if listed in the delivery scope.
Technical Data
Parameters:
No-load speed: 4500 - 11500 RPM
Amps: 8 AMPS
Rated input power: 900 W
Output power: 470 W
Type of edges: chamfer and radius
Max. chamfer width 45°: 1/4 "
Max. chamfer height at 45°: 5/32 "
Possible radii: R2 / R3
Grade cutting depth setting: 0.004 "
Curvature smallest internal Ø: 13 mm
Weight (without power cable): 5.5 lbs
Cable length: 13 ft
Noise emission:
Sound pressure level: 87 dB(A)
Sound power level (LwA): 98 dB(A)
Uncertainty of measurement K: 3 dB(A)
Scope of Delivery
- 2 Carbide indexable inserts 45° chamfer (ISO: DCMT 11 T 304)
- 2 Carbide indexable inserts radius R2
- 2 Carbide indexable inserts radius R3
- Guide fence
- Screwdriver for Torx screws 15
- Bow type handle
- MetaLoc case
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
