GRR-RIPPER 3D Pushblock
What's Included:
- Main body
- 1/2" Leg
- 1/4" Leg
- Center Leg
- Handle
- Balance Support
- Hardware
The GRR-RIPPER 3D Pushblock is engineered to give you the most accurate cuts possible while protecting your hands at all times. No other pushblock offers this level of precision, control, and safety. Make difficult cuts with ease, and prevent kickback like never before.
Three directions of force.
Three directions of force provide essential stability for superior precision, safety, and control.
- Downward pressure stabilizes work piece on a flat surface.
- Inward pressure against the fence virtually eliminates kickback.
- Forward pressure feeds stock consistently through the cut to eliminate burning and blade marks.
Virtually eliminates kickback on table saws.
Kickback occurs when the workpiece strays from the fence, and gets pinched between the saw blade and the fence. The rear teeth of the blade grab the workpiece, turning it into a dangerous projectile. The only way to avoid kickback is to maintain control of your workpiece through the entire cut.
The GRR-RIPPER provides downward and inward pressure, keeping both sides of the cut parallel to the blade. This prevents the workpiece from straying from the rip fence, virtually eliminating kickback.
Rip without stopping and burning.
Using two GRR-RIPPERs allows you to feed long stock continuously without stopping, virtually eliminating burning and blade marks caused by inconsistent feed rate. Parts come off the saw ready to use with little to no additional sanding or planning.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
