MATCHFIT 1" Dovetail Track Hardware Screw
What's Included:
- (4) 1" Dovetail Track Screws
- (4) Round Knobs
- (4) Shoulder Washers
With any standard 1/2" 14-degree dovetail router bit, you can create your own tracks, eliminating the need for expensive aluminum tracks. It's an entire system designed to give you all the functionality of t-track and t-track accessories, at a fraction of the cost.
The most versatile profile ever.
Create a variety of jigs that move freely, and tighten down anywhere you can route a groove.
- Compatible with standard ½" 14 degree dovetail profile.
- Includes (4) 10-32 1" long dovetail track screws with round knobs and shoulder washers (compatible with GRR-RIPPER system).
- Allows for 360 degree range of motion with dovetail grooves in grid layout.
- The included nylon shoulder washers are compatible with the accessory notches throughout the GRR-RIPPER line of products.
Make every inch of your workshop more functional.
Step 1
Route a groove with a ½†14-degree dovetail router bit.
Step 2
Dovetail Hardware moves through the tracks below the surface, securing material without getting in the way.
WASHING INSTRUCTIONS:
Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.
